Overview
-
Working Time:
half-hour – 1 hour
-
Complete Time:
half-hour – 1 hour
-
Yield:
1 plant hanger
-
Ability Degree:
Newbie
-
Estimated Price:
$5-10
Bohemian dwelling decor is again in vogue, which implies social media inspiration pages are awash with rattan, houseplants—so many houseplants—and earthy, pure tones. What embodies the boho aesthetic higher than macrame?
Macrame looks like a tough and time-consuming interest, however it does not need to be both of these issues with a easy sample—and relaxation assured: This one is the only. You may hardly need to be taught any fancy knots, and you’ll adapt the size of the cords to any measurement pot. Even skilled twine employees shall be drawn to the minimalistic look of those flower child-approved macrame plant hangers.
Knots to Know
You may want solely three important (and impossibly simple!) knots for this undertaking—and one in every of them you already know.
- Wrap knot: Used to safe a bundle of cords collectively, this knot is frequent for attaching cords to rings for plant hangers and tassels.
- Sq. knot: This is a crucial and common ornamental knot that’s extensively utilized in macrame to bind round an object (on this case, a plant).
- Overhand knot: The only of knots and one you virtually positively use repeatedly, the overhand or “single” knot is made by making a loop in a bit of twine and pulling one finish via.
Directions
-
Lower Your Wire
Lower eight items of twine, every the identical size—for a bigger plant, you will need them every to measure 10 ft. Then, minimize an extra, shorter piece a pair ft lengthy on your wrap knot.
-
Slip Cords Via Ring
Bundle your eight lengthy cords collectively so that they’re even in size and thread them collectively via the ring. You need the ring to land on the mid-point of the cords in order that once you fold them over the ring, you get 5, five-foot-long strands.
-
Safe With a Wrap Knot
Dorling Kindersley / Rob Streeter / Getty Photographs
Utilizing the shorter piece of twine you chop, create a “U” form, leaving about 4 inches of slack on the left finish of the twine. The “U” ought to be one to 2 inches lengthy. Left of the “U” shall be your “quick tail” and proper of the “U” your “lengthy tail.”
Place your “U” over the bundle, slightly below the ring, then start wrapping the lengthy tail across the bundled cords and over the “U” form. The quick tail ought to poke out from the highest of the coil. Maintain wrapping till you attain a size that appears good to you, stopping earlier than you attain the underside of the “U” so {that a} loop is left uncovered on the backside of the coil.
On the ultimate wrap, thread your lengthy tail down via that loop. Pull the lengthy tail to tighten the knot and the quick tail to drag the underside loop up into the knot. End by trimming the tails near the knot so they don’t seem to be seen.
-
Measure
Think about the plant you propose to place in your hanger. Is it a spiller? If that’s the case, it most likely does not want a lot headroom. If it is bushy, although, make sure that to not constrict it.
Divide your 16 strands into 4 teams of 4. When you determine how far down you need the highest of your pot to hit, mark it flippantly with a pencil—that is the place your first sq. knots will go.
-
Create Your First Row of Sq. Knots
Alla Simacheva / EyeEm / Getty Photographs
You may make a complete of eight sq. knots on this primary row—two on every four-cord bundle. To create one sq. knot, take one in every of your 4 bundles and separate the 2 outer strands from the remaining two within the center. The place you marked with a pencil, lay the left-side twine over the middle two cords however underneath the right-side twine. Then, thread the right-side twine underneath the middle cords and up via the outlet created on the left facet. You need to see an overhand knot with the 2 internal cords within the heart.
Repeat this and pull to tighten for one sq. knot, then repeat to make two conjoined sq. knots on every of the 4 bundles.
-
Create a Second Row of Sq. Knots
With this row, your planter ought to actually start taking form. You’ll be a part of your 4 bundles collectively now and create a round form by splitting every bundle into two with one internal twine and one outer twine. You need to have eight teams of two cords. Create new four-cord bundles by becoming a member of adjoining teams of two. Measure how far down you need your second row of sq. knots to be (ought to be about midway down the plant pot), mark the cords flippantly, and safe with two conjoined sq. knots as you probably did with the primary row.
-
End and Fill
Sarah Sosiak / EyeEm / Getty Photographs
To complete your macrame masterpiece, you are able to do one other wrap knot or a easy overhand knot utilizing all 16 cords. Be at liberty to trim the remaining twine ends in the event you choose shorter fringe.
Fill your DIY macrame plant hanger with one in every of your botanic infants, grasp from the ceiling utilizing the ring, and voila! You’ve a bohemian dream nook.